Juniper SRX220

Table 9: SRX220 Services Gateway Built-In Hardware
Interfaces (continued)
DescriptionSpecificationsInterface Type
The console port can be used
as follows:
•
To provide the console
interface.
•
To function as a
management port to log
into a device directly.
•
To configure the device
using the command-line
interface (CLI).
One port that:
•
Uses an RJ-45 serial cable
connector.
•
Supports the RS-232
(EIA-232) standard.
Console
The Mini-PIM slots can be
used to provide LAN and WAN
functionality along with
connectivity to various media
types.
For more information about
the supported Mini-PIMs, see
the SRX Series Services
Gateways for the Branch
Physical Interface Modules
Hardware Guide.
Two slots for Mini-PIMs.Mini-Physical Interface Module
(Mini-PIM)
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
Related
Documentation
SRX220 Services Gateway Specifications on page 29•
• SRX220 Services Gateway Front Panel and Back Panel Views on page 11
• SRX220 Services Gateway LEDs on page 16
• SRX220 Services Gateway Boot Devices and Dual-Root Partitioning Scheme on page 9
• SRX220 Services Gateway Cooling System on page 21
• SRX220 Services Gateway Power Supply on page 23
15Copyright © 2016, Juniper Networks, Inc.
Chapter 3: Chassis Description