Juniper SRX340 User Manual

Table 51: LED Indications for Hot-Swappable GPIM Components
(continued)
DescriptionComponentNumber
Push the button to turn the GPIM offline. After the STATUS
LED light goes off, it is safe to remove the GPIM from the
services gateway.
ONLINE/OFFLINE
button
2
3. Label the cables connected to the GPIM so that you can later reconnect each cable
to the correct GPIM.
4. Disconnect the cables from the GPIM.
5. If necessary, arrange the cables to prevent them from dislodging or developing stress
points.
6. Using a Phillips (+) screwdriver, loosen the captive screws on each side of the GPIM
faceplate.
7. Grasp the handles on each side of the GPIM faceplate, and slide the GPIM out of the
services gateway.
8. Place the GPIM in an electrostatic bag or on an antistatic mat.
9. If you are not reinstalling a GPIM into an empty slot, install a blank GPIM faceplate in
the empty slot to maintain proper airflow.
NOTE: When installing a blank GPIM faceplate, make sure that the padded
side of the faceplate is facing up.
Installing a Gigabit-Backplane Physical Interface Module
Before you begin:
•
Ensure that the services gateway is powered off.
•
Ensure that the GPIM is installed in the appropriate GPIM slot. For information about
the appropriate GPIM slots, see “SRX300 Series and SRX550 High Memory Services
Gateway Gigabit-Backplane Physical Interface Modules Overview” on page 4.
Copyright © 2017, Juniper Networks, Inc.100
SRX300 Series and SRX550 High Memory Gateway Interface Modules Reference

Juniper SRX340 Specifications

General

Firewall Throughput	3 Gbps
Maximum Concurrent Sessions	256, 000
Memory	4 GB
Redundant Power Supplies	No
Operating Temperature	32°F to 104°F (0°C to 40°C)
Humidity	10% to 90% non-condensing
Storage	8 GB