Preparing the SRX3600 Services Gateway for Rack-Mount or Cabinet
Installation
Before you begin the installation, verify the following:
•
Your site has been properly prepared for the services gateway. See “Site Preparation Checklist for the
SRX3600 Services Gateway” on page 65 for a summary of the tasks you need to perform.
•
The services gateway has been removed from the shipping container. See “Unpacking the SRX3600
Services Gateway” on page 103.
•
You have read the safety information in Chassis Lifting Guidelines.
•
Ensure the rack is in its permanent location and is secured to the building. Ensure that the installation
site allows adequate clearance for both airflow and maintenance. For details, see “Clearance Requirements
for Airflow and Hardware Maintenance of the SRX3600 Services Gateway” on page 69.
RELATED DOCUMENTATION
SRX3600 Services Gateway Definition of Safety Warning Levels.
Installing the Mounting Hardware for the SRX3600 Services Gateway | 109
Installing the SRX3600 Services Gateway in a Rack or Cabinet Using a Mechanical Lift | 114
Installing the SRX3600 Services Gateway in a Rack or Cabinet Using a
Mechanical Lift
1. Ensure the rack is in its permanent location and is secured to the building. Ensure that the installation
site allows adequate clearance for both airflow and maintenance. For details, see “Site Preparation
Checklist for the SRX3600 Services Gateway” on page 65.
2. Load the services gateway onto the lift, making sure it rests securely on the lift platform (see
Figure 43 on page 115).
114