Contacting Customer Support | 241
Required Tools and Parts for Packing the SRX3600 Services Gateway
To remove the components from the services gateway or to remove the services gateway from a rack,
you need the following tools and parts:
•
Blank panels to cover empty slots
•
Electrostatic bag or antistatic mat for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade screwdriver, approximately 1/4 in. (6 mm)
•
Phillips (+) screwdrivers, numbers 1 and 2
RELATED DOCUMENTATION
Return Procedure for the SRX3600 Services Gateway | 242
Packing the SRX3600 Services Gateway for Shipment | 248
Packing SRX3600 Services Gateway Components for Shipment | 249
Packing the SRX3600 Services Gateway for Shipment
To pack the services gateway for shipment:
1. Retrieve the shipping carton and packing materials in which the services gateway was originally shipped.
If you do not have these materials, contact your Juniper Networks representative about approved
packaging materials.
2. Attach an ESD grounding strap to your bare wrist and connect the strap to the ESD point on the chassis
or to an outside ESD point if the services gateway is disconnected from earth ground.
3. On the console or other management device connected to the services gateway, enter CLI operational
mode and issue the following command to shut down the services gateway software:
user@host> request system halt
248
To Next Page
Loading...
