Configuring Security Policies
To configure security policies:
1. From the J-Web Dashboard page, select Configure>Security>Security Policy and click Add. The Add
Policy dialog box appears.
2. In the Policy tab, enter the policy name and set the policy action to permit. Then select Zone and set
the From Zone to trust and the To Zone to untrust.
3. Configure the source IP address by selecting any listed under Available and moving it under Selected.
4. Configure the destination IP address by selecting any listed under Available and moving it under Selected.
5. Configure the application by selecting any listed under Available and moving it under Selected.
6. Click OK.
A message appears after your configuration changes are validated successfully.
7. Click OK.
8. Select Commit Options>Commit to apply the configuration changes.
A message appears after your configuration changes are applied successfully.
9. Click OK.
You have successfully configured the security policy.
164
To Next Page
Loading...
