CHAPTER 27
Replacing Cables and Connectors
IN THIS CHAPTER
Replacing SFP, SFP+, and XFP Transceivers on the SRX3600 Services Gateway | 203
Replacing SFP, SFP+, and XFP Transceivers on the SRX3600 Services
Gateway
Small form-factor pluggable (SFP), enhanced small form-factor pluggable (SFP+), and 10-Gigabit SFP (XFP)
are transceivers that you install in sockets in various cards or modules in the services gateway. These
transceivers are hot-insertable and hot-removable. Removing a transceiver does not interrupt the functioning
of the card or module, but the removed transceiver no longer receives or transmits data.
CAUTION: If you face a problem running a Juniper Networks device that uses a third-party
optic or cable, the Juniper Networks Technical Assistance Center (JTAC) can help you
diagnose the source of the problem. Your JTAC engineer might recommend that you
check the third-party optic or cable and potentially replace it with an equivalent Juniper
Networks optic or cable that is qualified for the device.
For the services gateway to meet NEBS and ETSI standards, all transceivers installed in the services gateway
must be of extended temperature (ET) type.Table 36 on page 203 describes the applicable transceivers
available from Juniper Networks.
Table 36: Extended Temperature SFP, SFP+, and XFP Transceivers
DescriptionSKU
1000BASE-LH SFP optical transceiverSRX-SFP-1GE-LH-ET
1000BASE-LX SFP optical transceiverSRX-SFP-1GE-LX-ET
1000BASE-SX SFP optical transceiverSRX-SFP-1GE-SX-ET
203
To Next Page
Loading...
Need help?
General
