11. Use the show chassis fpc pic-status command to make sure that all of the cards in the secondary node
chassis are back online.
12. Use the show chassis cluster status command to make sure that the priority for all redundancy groups
is greater than zero.
13. Use the console port on the device that is the primary node to establish a CLI session.
14. In the CLI session for the primary node device, use the request chassis cluster failover command to
fail over each redundancy group that has an ID number greater than zero.
For example:
admin@node0_device> request chassis cluster failover redundancy-group 1 node 1
admin@node0_device> request chassis cluster failover redundancy-group 2 node 1
admin@node01_device> request chassis cluster failover redundancy-group 3 node 1
admin@node0_device> request chassis cluster failover redundancy-group 4 node 1
15. If the services gateway has only one SPC in it and the full-cp-key license is installed, remove the full-cp-key
license as described in Step 5.
16. In the CLI session for the primary node device, use the request system power off command to shut
down the services gateway. This action causes redundancy group 0 to fail over onto the other services
gateway, making it the active node in the cluster.
17. Install the new SPC or SPCs in the powered-off services gateway using the procedure in “Installing
CFM Cards in the SRX3600 Services Gateway” on page 125.
18. Power on the services gateway and wait for it to finish starting.
19. Use the show chassis fpc pic-status command on each node to confirm that all cards are online and
both services gateways are operating correctly.
20. Use the show chassis cluster status command to make sure that the priority for all redundancy groups
is greater than zero.
130
To Next Page
Loading...
Need help?
General
