Figure 60: Connecting to AC Power
3. Snap the wire bail on the power supply over the power cord to prevent the power cord from accidentally
disengaging.
4. Insert the power cord plug into an external AC power source receptacle.
NOTE: Each power supply must be connected to a dedicated AC power feed and a dedicated
external circuit breaker. We recommend that you use a 15 A (250 VAC) minimum, or as permitted
by local code.
5. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust and
access to services gateway components or drape where people could trip on it.
6. Repeat steps 1 through 5 for the remaining power supplies.
NOTE: If power is lost to the services gateway, the Power-On/Power-Off state is retained. For
example, if the services gateway loses power while it is switched on, when power returns, the
services gateway will still be in the On state.
RELATED DOCUMENTATION
146
To Next Page
Loading...
