Table 10: Supported Slots for SRX1400, SRX3400, and SRX3600 Services Gateway Modules (continued)
Supported Slots
Module Name and
Number SRX3600SRX3400SRX1400
Front slots labeled 1-6 and
rear slots labeled 7-12. We
recommend that you install
IOCs in front panel slots to
simplify cable management.
Front slots labeled 1-4
and rear slots labeled 5-7.
We recommend that you
install IOCs in front panel
slots to simplify cable
management.
Slot 2“Network Processing I/O
Card
SRX1K3K-NP-2XGE-SFPP”
on page 42
Rear slot labeled RE0. (SRX3K-RE-12-10 only)Front slot labeled RE
(SRX1K-RE-12-10 only)
“Routing Engines
SRX3K-RE-12-10 and
SRX1K-RE-12-10” on
page 45
Rear slot labeled RE1.Not Applicable“SRX Clustering Module
SRX3K-CRM” on page 47
NOTE:
•
For the SRX3400 and SRX3600 Services Gateways to meet NEBS and ETSI standards, they must
not have any two SPCs installed side by side in the CFM slots in the front of the chassis (CFM
slots 1 through 4 in the SRX3400, CFM Slots 1 through 6 in the SRX3600). You can install SPCs
side by side in the CFM slots in the rear of the chassis (CFM slots 5 through 7 in the SRX3400,
CFM slots 7 through 12 in the SRX3600).
•
When an SRX3400 or SRX3600 Services Gateway is in the Express Path (formerly known as
Services Offload) mode supported in Junos OS release 12.1X44-D10 and later, IOCs are only
supported in front panel slots 1 through 3. See the Junos OS documentation for more information
about Express Path mode.
RELATED DOCUMENTATION
SRX1400, SRX3400, and SRX3600 Services Gateway Module Overview | 27
Modules Supported on SRX1400, SRX3400, and SRX3600 Services Gateways | 28
Installing Common Form Factor Modules In SRX1400, SRX3400, and SRX3600 Services Gateways
31
To Next Page
Loading...
Need help?
General
