3-17
• COM Port selection
From COM1 to COM4, select the COM port to which
the communication cable is connected.
•
System Option...
Select the TV signal format and the model of the con-
nected VCR.
•
IEEE1394 ID Setting
ID setting utility of the IEEE1394 standard. (See 3.7.13.)
•
Emulation Mode ON/OFF
The emulation mode makes it possible to use the adjust-
ment software even when communication with the VCR
is not available. As the following window is displayed in
case of a communication error, check “Enter the Emula-
tion Mode”.
3.7.6 Common Operations for Adjustments
Note: Before adjustment, be sure to save the EEPROM
data in a PC file as the backup for use in case of
adjustment failure. (See 3.6.12.)
(1) Under the [
Adjustment] tab, check [Adjustment Explorer].
(2) Click the desired adjustment items.
(3) To monitor the video output from the VCR Unit, press the
PLAY button of the operation switches of the main unit. If
the color bar signal has been recorded in the VCR Unit, the
playback screen becomes as shown below, but this is not a
malfunction (BR-DV600).
4
[Option] tab
Fig. 3-7-8
5
[Help] tab
Displays the version information of the adjustment software.
6
VCR Controller
Controls the VCR operations.
7
ROM Tools
Used to check, save, print, modify the memory in the
EEPROM (IC103 on DV Main board) or to initialize it. (See
3.7.12.)
8
DSP Controller
Used to control the TV signal generator in the VTR Unit,
switch SHUFFLE, CONCEALMENT and VITERBI ON/OFF.
Clicking “
” resets them to the defaults.
9
COM port display
Shows the COM port in use.
0
Communication status display
Shows one of the following messages according to the com-
munication status.
CONNECTED: Normal communication
UNKNOWN: Communication error
EMULATION MODE: In emulation mode
Fig. 3-7-9
!
ROM file display
Shows the file name or “Current VCR data” while a ROM
tool reads EEPROM data. Clicking [ROM
Monitor] under the
2
[View] tab displays the data contents.
Fig. 3-7-10
Fig. 3-7-11
(4) After completing each adjustment item, click the “v” mark-
ing, then switch the set OFF.
(5) To cancel the adjutment, click the “G” marking.
Note: If another adjustment is started without clicking the
“v” marking, the previous adjustment cannot be
stored in memory.
3-16
To Next Page
Loading...
