6 of 40
Programming
How Programming Works
This controller has been designed with 5 separate programs to allow
different landscape areas to have their own individual watering schedules
L A PROGRAM is a method of grouping zones (valves) with similar
watering requirements to water on the same days. These zones
will water in sequential order and on the days selected
L Group the zones (valves) which are watering similar landscape areas
together. For example, turf, flower beds, gardens–these different
groups may require individual watering schedules, or PROGRAMS
L Set the current time and correct day of the week. If odd
or even day watering is going to be used, make sure the
current year, month and day of the month is correct
® If left unattended for over 1 minute, the LCD display will return to
AUTO no matter the position of the MAIN DIAL. If you were in
the process of programming this controller, turn dial to AUTO and
then back to the position you were programming to continue
To Next Page
Loading...
