SAM
®
RF Operations Manual 94
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating Master Keys (continued)
9. Back at the Create Master Key PC
dialog box, the name of the
person you selected will appear in
the box under the words, “The
Key Is Assigned To.”
10. When you are satisfied with the
settings for this key, insert a key
into the encoder and click OK.
Note: You must keep the key in the electronic key encoder base while the key image
spins on the PC screen.
Note: Whenever you select the New Key option, a
Warning PC dialog box will appear, indicating that
creating a new key will cancel any other keys of
the same type. If this is the first key of this type you
are creating, click Yes to proceed. Otherwise, click
No to return to the Create Master Key PC dialog
box and select the Duplicate Key option.
Note: If a key is not currently in the electronic key encoder, the PC will display an error screen until you
insert a key into the electronic key encoder.
Note: You must keep the USB cable
connected between the electronic key
encoder base and the PC while the
key image spins on the PC screen.
The PC screen will display, “The write
operation was successful!”
To Next Page
Loading...