Kaba Saflok SAM RF - Page 109

SAM
®
RF Operations Manual 103
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating Zone Keys (continued)
9. Back at the Create Zone Key PC dialog box,
the name of the person you selected will
appear in the box under the words, “The Key
Is Assigned To.” You will now confirm the
default settings for the common access areas
for this zone. These default settings were set
up in the site design process and will not likely
require any changes. However, you may
choose to limit select common access lock(s)
by a zone key. If so, select the common
access locks you wish to assign or unassign
the particular key by clicking in the squares
next to the inside the common access lock PC
dialog box area.
10. When you are satisfied with the settings for
this key, insert a key into the encoder and click
OK.
Note: You must keep the key in the electronic key encoder base while the key image
spins on the PC screen.
Note: Whenever you select the New Key option, a Warning
PC dialog box will appear, indicating that creating a new key
will cancel any other keys of the same type. If this is the first
key of this type you are creating, click Yes to proceed.
Otherwise, click No to return to the Create Zone Key PC
dialog box and select the Duplicate Key option.
Note: If a key is not currently in the electronic key encoder, the PC will display an error screen until you
insert a key into the electronic key encoder.
Note: You must keep the USB cable connected between the electronic key encoder base and the PC
while the key image spins on the PC screen. The PC screen will display, “The write operation was
successful! The KEY ID for this key is 1.”