1312
Please read the following instructions carefully to ensure that your
beverages are of the highest quality.
The beverage supply temperature is very high. Please, be careful!
• Coffee beans should be stored in a dry place out of direct
sunlight.
• Only fill the water tank with fresh cold water.
• For perfect quality beverages, change the water in the
tank daily.
• Please preheat the cup before making coffee for the
best taste.
• Please adjust the height of the coffee spout to the height
of the cup to avoid splashing.
• The coffee spout height adjustment range is 100-165mm.
Press and hold the ON/OFF button to turn off the coffee machine. When you turn off the
coffee machine, a rinsing cycle starts automatically.
•
During rinsing, a small amount of hot water is supplied through coffee spout
•
Please avoid contact with hot water.
Condition:
If you have prepared beverages with milk, the cappuccino rinsing function will become
available when you turn off the coffee machine.
Press and hold the ON/OFF button for 2 seconds. Message on the display: "REMOVE
THE MILK PIPE FROM THE MILK TANK AND INSERT IT INTO THE TRAY".
•
Remove the pipe from the milk carton, disconnect from the thermos container and insert
into the round hole of the drip tray.
Press "OK" to start the flushing process. The Auto-Cappuccino system and the coffee
spout are being rinsed. At the end of the process, the coffee machine turns off.
Making beverages
Making beverages by pressing the touch button-indicator
Please warm up the cup before preparing your drink.
The recommended volume for preparing Espresso is 30-50 ml.
The recommended volume for making Americano is 150-200 ml
You can prepare 20 types of coffee drinks by pressing the corresponding touch icon.
For example, consider the process of making espresso.
To start the espresso preparation process, press the ESPRESSO touch icon.
By using the navigation buttons during grinding you can
select the desired strength. The default setting for strength
is -
Using the navigation icons, at the time of dispensing water,
you can select the desired volume. Espresso is set to 45 ml
by default.
The process of dispensing a beverage can be stopped by
pressing the touch button - the CANCEL indicator.
Once a drink has been prepared, the settings will not be
saved. At the end of the process, the touch icons for
preparing beverages will appear on the display.
To prepare a cappuccino, connect the milk pipe to the
cappuccino maker through the adapter. Dip the free end of
the pipe into the milk carton and press the CAPPUCCINO
touch icon.
Using the navigation icons, at the time of preparation you can
select the desired strength, amount of water and milk foam.
Once a drink has been prepared, the settings will not be
saved.
Making cappuccino
Power off
To Next Page
Loading...