KaVo ERGOcom 3 - Setting Video Output 2

ERGOcom 3
5 Operation | 5.2 Operation, no display interface (classic)
▶ Hold down the VIDEO OUT 1 button for < 2 seconds.
The last image source selected is shown in the status display. The status display
returns to operational mode after 5 seconds.
See also: 5.2.1 Operational mode, Page 27
▶ Hold down VIDEO OUT 1 for > 2 seconds.
The status display flashes and setting mode is activated.
▶ Select the required VIDEO input by pressing the VIDEO OUT 1 button.
Note
If there is no input for 8 seconds, the ERGOcom 3 switches back to operational
mode.
This saves the last setting on the status display.
31/56