KaVo ERGOcom 3 - Generating and Saving Still Images

ERGOcom 3
5 Operation | 5.2 Operation, no display interface (classic)
5.2.4 VIDEO OUT 2 - set image source
▶ Hold down the VIDEO OUT 2 button for < 2 seconds.
The last image source selected is shown in the status display. The status display
returns to operational mode after 5 seconds.
See also: 5.2.1 Operational mode, Page 27
▶ Hold down the VIDEO OUT 2 button for > 2 seconds.
The status display flashes and setting mode is activated.
▶ Select the required VIDEO input by pressing the VIDEO OUT 2 button.
32/56