KaVo ERGOcom 3 - Setting VGA Output Source

ERGOcom 3
5 Operation | 5.3 Operation, with display interface (comfort/excellence)
▶ Select the required VIDEO input by pressing the VIDEO IN button.
Note
If no image source is connected to VIDEO IN 1/2, the logo set in the OSD menu
display interface will be displayed.
See also:
5.4.5 Menu point, other, Page 49
5.3.2 VGA OUT - set image source
▶ Hold down the VGA OUT button for < 2 seconds.
The last image source selected is shown in the status display. The status display
returns to operational mode after 5 seconds.
37/56