ERGOcom 3
5 Operation | 5.3 Operation, with display interface (comfort/excellence)
▶ Select the required VGA input by pressing the VGA IN button.
Note
If no image source is connected to VIDEO IN 1/2, the logo set in the OSD menu
display interface will be displayed.
See also:
5.4.5 Menu point, other, Page 49
VIDEO IN - set image source
▶ Press the VIDEO IN button.
If a VGA image source was selected before, the last VIDEO IN image source
selected will be shown in the status display.
36/56
To Next Page
Loading...
