Kawai MP7SE - (E.PIANO, HARPSICHORD, BASS Sounds); Virtual Technician; (DRAWBAR Sounds); Stereo Width

53
EDIT Menu
EDIT Menu parameters (INT mode)
8. Fall-back Noise value: off, 1 ~ 10
This parameter adjusts the volume of the noise heard when the
keyboard action ‘falls back’ after a key is released.
9. Topboard close, open1, open2, open3
This parameter changes the position of the piano’s topboard.
When playing an acoustic grand piano, the position of the instrument’s
topboard (lid) aects both the volume and ‘openness’ of the tone produced.
A fully open topboard allows sound waves to reect o the polished lid
surface and project into the room, while a closed lid has the opposite eect,
resulting in a darker, more opaque tone.
10. Stereo Width
value: 0 ~ 127
This parameter adjusts the width of the stereo sound.
Virtual Technician (E.PIANO, HARPSICHORD, BASS sounds)
1. Key-o Noise value: off, 1 ~ 127
When an E.PIANO category sound is selected, this parameter
adjusts the volume of the noise heard when the keys of an
electromechanical instrument are released.
When a harpsichord or bass sound is selected this parameter
adjusts the volume of the release noise for harpsichord and
bass sounds.
2. Key-o Delay value: 0 ~ 127
This parameter adjusts the delay time before the Key-o Noise
is heard.
Virtual Technician (DRAWBAR sounds)
1. Key Click Level value: off, 1 ~ 127
This parameter adjusts the volume of the key click sound when
playing drawbar organ sounds.
2. Wheel Noise Level value: 0 ~ 127
This parameter adjusts the volume of the ambient noise
produced by the organ’s spinning tonewheels.
Increase the value of this parameter to give the tonewheel organ a more
vintage character.