Kawai MP7SE - Controllers; Pitch Bend Range

60
EDIT Menu
EDIT Menu parameters (EXT mode)
6 Controllers
1. Damper Pedal
on, off
This parameter determines whether or not the included F-10H
damper pedal is active for the selected zone.
* For more information about connecting pedals, please refer to page 17.
2. Damper Pedal Assign cc#0 ~ cc#119, aftertoucH
This parameter selects the function assigned to the included
F-10H damper pedal.
* This parameter is common for all four zones.
3. Half Pedal Values
normal, HigH, low, mid HigH, mid low
This parameter changes the half pedal ranges sent by the included F-10H damper pedal for the selected zone.
This parameter is useful when using the MP7SE to control external tone generators (e.g. software pianos) that respond to damper pedal behaviour dierently.
Half Pedal Value Value Range Description
Normal
(default) 0 ~ 127 The damper pedal sends a full range of evenly distributed values.
High 0, 64 ~ 127 The damper pedal sends a full range of evenly distributed values after the half-pedal point is reached.
Low 0 ~ 63, 127 The damper pedal sends a full range of evenly distributed values before the half-pedal point is reached.
Mid High 0, 50 ~ 100, 127 The damper pedal sends a full range of evenly distributed values between 50 and 100.
Mid Low 0, 25 ~ 75, 127 The damper pedal sends a full range of evenly distributed values between 25 and 75.
4. Pitch Bend on, off
This parameter determines whether or not the pitch bend
wheel is active for the selected zone.
5. Pitch Bend Range value: 0 ~ 12
This parameter sets the range of the pitch bend wheel in semi-
tone steps.
* The range diers for INT mode (0 ~7) and EXT mode (0~12).
6. Modulation Wheel on, reverse, off
This parameter determines whether or not the modulation
wheel is active for the selected zone.
When set to ‘Reverse’, the wheel’s output values will be inverted.
7. Modulation Wheel Assign
cc#0 ~ cc#119,
aftertoucH
This parameter selects the function assigned to the MP7SE’s
modulation wheel.
8. Modulation Depth Range value: 0 ~ 127
This parameter sets the range of the pitch modulation function
in steps of 600/127 cents.
9. Footswitch Pedal on, off
This parameter determines whether or not the footswitch pedal
(if connected) is active for the selected sound.
* For more information about connecting pedals, please refer to page 18.
10. Footswitch Pedal Assign
cc#0 ~ cc#119,
aftertoucH
This parameter selects the function assigned to the footswitch
pedal (if connected).
* This parameter is common for all four zones.