Kawai MP7SE - Sound

42
EDIT Menu
EDIT Menu parameters (INT mode)
3 Sound
1. Master Volume
value: 0 ~ 127
This parameter adjusts the total SETUP volume, allowing the
volume of multiple SETUPs to be balanced.
* This parameter is common for all four zones.
* This parameter is not stored to SOUND but to SETUP only.
2. Panpot value: l64 ~ r63
This parameter adjusts the left/right position of the selected
sound within the stereo eld.
3. Filter Cut-o
value: –64 ~ +63
This parameter adjusts the frequency of the cut-o. Raising
the cut-o level increases the brightness of the sound, while
lowering the cut-o level results in a duller sound.
4. Filter Resonance value: –64 ~ +63
This parameter adjusts the amount of the harmonic overtone
around the cut-o frequency for the selected sound.
5. DCA Attack Time value: –64 ~ +63
This parameter adjusts the length of the attack. Higher values
increase the attack time, resulting in a longer, slower attack for
the selected sound.
6. DCA Decay Time value: –64 ~ +63
This parameter adjusts the length of the decay from peak level
to sustain level for the selected sound.
7. DCA Sustain Level value: –64 ~ +63
This parameter adjusts the volume level of the sustain heard
while the key is held for the selected sound.
8. DCA Release Time value: –64 ~ +63
This parameter adjusts the amount of time required for the
sound to fade out after the keys are released for the selected
sound.
9. DCF Attack Time value: –64 ~ +63
This parameter adjusts the length of the lter’s attack. Higher
values increase the attack time, resulting in a longer, slower
attack for the lter.
10. DCF Attack Level value: –64 ~ +63
This parameter adjusts the level of the lter’s attack.
11. DCF Decay Time value: –64 ~ +63
This parameter adjusts the length of the decay from peak level
to sustain level for the lter.
12. DCF Sustain Level value: –64 ~ +63
This parameter adjusts the level of the lter’s sustain heard
while the key is held for the selected sound.
13. DCF Release Time value: –64 ~ +63
This parameter adjusts the amount of time required for the lter
to fade out after the keys are released.
14. DCF Touch Depth value: –64 ~ +63
This parameter adjusts how much the velocity aects the lter
envelope depth.
15. DCA Touch Depth value: –64 ~ +63
This parameter adjusts how much the velocity aects the
amplitude envelope depth.
* With the exception of Volume, the Sound parameters on these pages will
not be available when tonewheel organ mode is selected.