Kawai MP7SE - Page 43

43
EDIT Menu
EDIT Menu parameters (INT mode)
16. Vibrate Depth value: –64 ~ +63
This parameter adjusts the depth of the vibration applied to the
selected sound.
17. Vibrate Rate value: –64 ~ +63
This parameter adjusts the speed of the vibration applied to the
selected sound.
18. Vibrate Delay value: –64 ~ +63
This parameter adjusts the delay time before the start of the
vibration.
19. Octave Layer Switch off, on
This parameter turns the additional Octave Layer ON or OFF.
20. Octave Layer Level value: 0 ~ 127
This parameter adjusts the volume level of the Octave Layer.
21. Octave Layer Range value: –2 ~ +2
This parameter sets the amount of octave transposition for the
Octave Layer.
22. Octave Layer Detune value: –64 ~ +63
This parameter adjusts the tuning of the Octave Layer.
23. Portamento off, on
This parameter turns portamento playing ON or OFF.
Portamento describes the eect of pitch sliding from one note to another.
24. Portamento Time value: 0 ~ 127
This parameter adjusts the time required for the portamento
(i.e. the speed of the ‘slide’ between notes).
25. Portamento Mode rate, equal
This parameter changes the portamento mode.
Portamento Mode Description
Rate The time required for the portamento will be variable. The distance between notes will aect the portamento time.
Equal The time required for the portamento will be constant. The distance between notes will not aect the portamento time.
Time
Volume
Key ON Key OFF
5
6
7
8

About DCA Parameters
The DCA (Digitally Controlled Amplier) parameters, are used to
adjust the volume level of a sound over time using an envelope.
The diagram below indicates the MP7SE’s DCA parameters.

About DCF Parameters
The DCF (Digitally Controlled Filter) parameters, are used to
adjust a low-pass lter applied to the sound over time.
The diagram below indicates the MP7SE’s DCF parameters.
Time
Frequency
Key ON Key OFF
9
11
12
13
10