Keithley 2100 User Manual

B-32 Return to Section Topics 2100-900-01 Rev. D / September 2011
Appendix B: Remote Interface Reference Model 2100 6 1/2-Digit Resolution Digital Multimeter User’s Manual
MsgBox "Open device failed.", vbExclamation, "2100 multimeter device test"
stat = viClose(fList)
Exit Sub
End If
Rem send reset command '*RST' -- reset 2100
stat = viWrite(sesn, "*RST", 4, ret)
If (stat < VI_SUCCESS) Then
MsgBox "System command error. (*RST)", vbExclamation, "2100 multimeter device
test"
stat = viClose(fList)
Exit Sub
End If
Rem send Clear command '*CLS'-- Clear 2100 status register
stat = viWrite(sesn, "*CLS", 4, ret)
If (stat < VI_SUCCESS) Then
MsgBox "System command error. (*CLS)", vbExclamation, "2100 multimeter device
test"
stat = viClose(fList)
Exit Sub
End If
Rem send measure command -- Set to 0.1 volt dc range
stat = viWrite(sesn, "meas:volt:DC? 0.1,0.01", 22, ret)
If (stat < VI_SUCCESS) Then
MsgBox "System command error. (meas:volt:dc? ...)", vbExclamation, "2100
multimeter device test"
stat = viClose(fList)
Exit Sub
End If
Rem fetch the measure data
stat = viRead(sesn, readin, 64, ret)
If (stat < VI_SUCCESS) Then
MsgBox "Read in data error.", vbExclamation, "2100 multimeter device test"
stat = viClose(fList)
Exit Sub
End If
Debug.Print "Rdg = "; readin
Rem set to local mode
stat = viWrite(sesn, "system:local", 12, ret)
If (stat < VI_SUCCESS) Then
MsgBox "System command error. (system:local)", vbExclamation, "2100
multimeter device test"
stat = viClose(fList)
Exit Sub
End If
stat = viClose(sesn)
stat = viClose(fList)
stat = viClose(dfltRM)
MsgBox "End of Job."
End Sub
Using CONFigure with a math operation

Keithley 2100 Specifications

General

DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Resistance Range	100 Ω to 100 MΩ
Continuity	Yes
Diode Test	Yes
Frequency Range	3 Hz to 300 kHz
DC Voltage Accuracy	0.0035%
DC Current Range	100 µA to 10 A
DC Current Accuracy	0.05%
AC Current Range	100 µA to 10 A
Frequency Accuracy	0.01%
Capacitance Range	1 nF to 10 mF
Temperature Range	-200 °C
Connectivity	RS-232
Type	6.5-digit digital multimeter