Kemppi X5 FastMig Series - Installing Wire Feeder with Fixed Plate

X5 FastMig
Operating manual - EN
2.4 Installing wire feeder with fixed plate
This section describes the fixed installation of the wire feeder (on top of the power source).
For stacked installation, additional support is required. Read the installation notes here: "Installation" on page19.
Tools needed:
1. Place the front fixing plate on the power source and secure it in place with the screws (M6x30) provided.
2. Place the rear fixing plate and the wire feeder locking mechanism on the power source. Secure them in place
with the screws (M6x40) provided.
© Kemppi
28 1920960 / 2039