Kemppi X5 FastMig Series User Manual

X5 FastMig
Operating manual - EN
3.4 Additional guidance to functions and features
This section summarizes some of the X5 FastMig functions and features and how to use them.
The use of additional welding programs and Wise features is possible with the X5 FastMig Synergic equipment.
"Trigger logic functions" below
"WiseFusion" below
"WisePenetration+" on the next page
"WiseSteel" on the next page
"WeldEye with DCM (optional)" on page84
3.4.1 Trigger logic functions
With X5 Wire Feeder 300 Manual you can select the trigger logic by pressing the trigger logic selection button in the
control panel.
With X5 Wire Feeder 300 Auto you can select the trigger logic in the Welding parameters view.
2T
In 2T, pressing the trigger ignites the arc. Releasing the trigger switches the arc off.
4T
In 4T, pressing the trigger starts the Pre gas, and releasing the trigger ignites the arc. Pressing the trigger again
switches the arc off. Releasing the trigger ends the Post gas.
3.4.2 WiseFusion
Available with automatic 1-MIG-enabled equipment only.
The WiseFusion welding function enables adaptive arc length control, which keeps the arc optimally short and
focused. WiseFusion increases the welding speed and penetration and decreases heat input. WiseFusion can be used
© Kemppi
82 1920960 / 2039

Kemppi X5 FastMig Series Specifications

General

Brand	Kemppi
Model	X5 FastMig Series
Category	Welding System
Language	English