Kemppi X5 FastMig Series - Auto Control Panel: Info View

X5 FastMig
Operating manual - EN
Post gas
0.0 ... 9.9 s, step 0.1
0.0 = OFF
Welding function that continues the shield-
ing gas flow after the arc has extinguished.
This ensures that thehot weld does not
come into contact with air after the arc is
extinguished, protecting the weld and also
the electrode. Used for all metals. Especially
stainless steeland titaniumrequirelonger
post gas times.
Current
10 ... machinesize A, step 1
Default = 50 A
Welding current adjustment.
MMA welding parameters
The parameters listed here are available for adjustment with the MMA process.
Parameter Parameter value Description
Dynamics
-10.0 ... +10.0, step 0.2
Default = 0
Controls theshort circuit behavior of the
arc. The lower the valuethesofter the arc,
the higherthe valuetherougherthe arc.
Hot start level (MMA)
-30 ... +30
Default = 0
Welding function that uses higheror lower
wirefeed speed and welding current at the
start of the weld. Afterthe Hot start period
the current changes to normal welding cur-
rent level. This facilitates the start of the
weld especially with aluminum materials. In
MMA theHot start level is preset by the
user.
Current
10 ... machinesize A, step 1
Default = 50 A
Welding current adjustment.
Gouging parameters
The parameters listed here are available for adjustment with the gouging process.
Parameter Parameter value Description
Current
10 ... machinesize A, step 1
Default = 50 A
Current adjustment.
3.3.5 Auto control panel: Info view
The Info view shows information on the device usage. Through this view it is also possible to access the error logs,
list of installed welding programs, additional operating information and device info, such as the software version
and equipment serial numbers.
© Kemppi
76 1920960 / 2039