Kemppi X5 FastMig Series - Other Optional Accessories

X5 FastMig
Operating manual - EN
2.14 Other optional accessories
In addition to the accessories covered in the installation chapters, X5 FastMig has also several other accessories to
facilitate its use and improve welding quality.
When installing the full set of equipment stacked as a tower and using the double wire feeder rotating plate or coun-
terbalance arm, always use the broader front roller support plate delivered with the equipment. This applies to the 4
wheel cart.
Read also the installation notes here: "Installation" on page19.
Wire drum kit
To use the wire drum kit, drill a hole at the back of X5 Wire Feeder's transparent cover.
Wire feeder hanger for boom
The wire feeder hanger for boom facilitates welding where it is difficult to bring the full X5 FastMig welding system.
Do not hang the wire feeder from the handle. Use the wire feeder hanger for boom instead.
© Kemppi
56 1920960 / 2039