Kemppi X5 FastMig Series User Manual

X5 FastMig
Operating manual - EN
2.8 Installing remote control
Remote controls are optional. To enable remote operation, set the remote control mode in the control panel settings
("Auto control panel: System settings" on page78 or "Manual control panel: Settings" on page64).
Remote control HR43
1. Connect the remote control cable to the wire feeder.
Tip: You can set minimum and maximum values for the remote adjustment in the control panel settings.
© Kemppi
40 1920960 / 2039

Kemppi X5 FastMig Series Specifications

General

Brand	Kemppi
Model	X5 FastMig Series
Category	Welding System
Language	English