X5 FastMig
Operating manual - EN
3.3.7 Auto control panel: System settings
Changing settings
1. Turn the right control knob to highlight the desired settings parameter.
2. Press the right control knob to select the settings parameter for adjustment.
3. Turn the right control knob to select the settings value.
>> Depending on the settings parameter to be adjusted, refer also to the Settings table below for more details.
4. Confirm the new value / selection and close the adjustment view by pressing the right control knob.
Users
The system settings can be customized for up to 10 different users. In addition to the system settings, the memory
channels are user-specific. Each user can have up to 100 MIG channels, 10 TIG channels, 10 MMA channels and 10 gou-
ging channels. The memory channel and system settings are saved automatically for the logged-in user.
Settings
Parameter Parameter value Description
User
Current user Thereisalways a logged-in user in the sys-
tem. When a new user logs in, the previous
user is automatically logged out.
Operation mode
MIG/TIG/MMA/Gouging
Remote control
OFF/Remote/Gun
Default = OFF
If remote controller is not connected, this
selection is not available.
Remote mode
Wirefeed speed / Channel This determines what is changed with the
remote, parameteror memory channel
(available channels:0...4). If remote con-
troller isnot connected and remote not
selected, this selection is not available.
© Kemppi
78 1920960 / 2039
To Next Page
Loading...
Need help?
General
