Kemppi X5 FastMig Series User Manual

X5 FastMig
Operating manual - EN
8. Follow the previous steps in reverse to install the wire feed rolls. Align the cut on the drive rolls' bottom with the
pin on the drive shaft.
9. Reattach the mounting caps and mounting pins to lock the drive and pressure rolls into their places.
10. Close the locking arms and lower the pressure handles on the feed rolls. Refer to "Installing and changing wire"
on page41 for more information on the wire installation.
11. Close the wire feeder top cover.
© Kemppi
50 1920960 / 2039

Kemppi X5 FastMig Series Specifications

General

Brand	Kemppi
Model	X5 FastMig Series
Category	Welding System
Language	English