Kemppi X5 FastMig Series - 2.12 Installing Gas Bottle and Testing Gas Flow

X5 FastMig
Operating manual - EN
5. Open the gas bottle valve.
6. Press the Gas test button in the wire feeder cabinet to flush the previous shielding gas and to run the new gas
into the system.
Use this button also to test that the gases flow through the system properly.
7. Press the Gas test button again to adjust the gas flow. Use either the built-in rotameter or an external flow
meterand regulator for measuring and adjustment.
© Kemppi
54 1920960 / 2039