Keysight E5260/E5270 Programming Guide, Edition 4 3- 5
Programming Examples
Programming Basics for Visual Basic .NET Users
To Create Measurement Program
Create the measurement program as shown below. The following procedure needs
your project template. If the procedure does not fit your programming environment,
arrange it to suit your environment.
Step 1. Plan the automatic measurements. Then decide the following items:
• Measurement devices
Discrete, packaged, on-wafer, and so on.
• Parameters/characteristics to be measured
h
FE
, Vth, sheet resistance, and so on.
• Measurement method
Spot measurement, staircase sweep measurement, and so on.
Step 2. Make a copy of your project template (e.g. \test\my_temp to \test\dev_a\my_temp).
Step 3. Rename the copy (e.g. \test\dev_a\my_temp to \test\dev_a\spot_id).
Step 4. Launch Visual Basic .NET.
Step 5. Open the project (e.g. \test\dev_a\spot_id).
Step 6. Open the module that contains the template code as shown in Table 3-1. On the code
window, complete the perform_meas subprogram.
Step 7. Insert the code to display, store, or calculate data into the subprogram.
Step 8. Save the project (e.g. \test\dev_a\spot_id).
To Next Page
Loading...
Need help?
General
