1- 12 Keysight E5260/E5270 Programming Guide, Edition 4
Programming Basics
Getting Started
To Pause Command Execution
To pause command execution until the specified wait time has elapsed, send the PA
command.
Example OUTPUT @E5270;"PA 5"
If this command is sent, the E5260/E5270 waits 5 seconds before executing the next
command.
To Start Measurement
To start measurement other than the high speed spot measurement, send the XE
command.
Example OUTPUT @E5270;"XE"
This starts the measurement specified by the MM command.
For the high speed spot measurement, refer to “To Perform High Speed Spot
Measurement” on page 1-18.
To Force 0 V
To force 0 V immediately, send the DZ command. The E5260/E5270 memorizes the
present source output settings of the specified channel, and changes the specified
channel output to 0 V. If you do not specify the channel, the DZ command function
is effective for all channels.
Example OUTPUT @E5270;"DZ 1"
If this command is sent, the E5260/E5270 memorizes the current settings of channel
1 (the module installed in slot 1 of the E5260/E5270), and changes channel
1 output
to 0 V.
To restore the settings stored by the DZ command, send the RZ command. For
details, refer to
Chapter 4, “Command Reference.”
To Next Page
Loading...
Need help?
General
