1- 8 Keysight E5260/E5270 Programming Guide, Edition 4
Programming Basics
Getting Started
To Force Voltage/Current
The E5260/E5270 provides the following commands to enable the voltage/current
output. For the commands available for each measurement mode, see
Table 1-1.
where, the PT command is used to set the timing parameters of the pulsed bias
source or pulsed sweep source.
Command Description
DV, TDV Forces the constant voltage immediately.
DI, TDI Forces the constant current immediately.
WV Sets the staircase sweep voltage source.
WSV Sets the synchronous sweep voltage source.
WI Sets the staircase sweep current source.
WSI Sets the synchronous sweep current source.
PV / PT Sets the pulsed voltage source.
PI / PT Sets the pulsed current source.
PWV / PT Sets the pulsed sweep voltage source.
PWI / PT Sets the pulsed sweep current source.
WNX Sets a sweep source for the multi sweep measurement.
BDV Sets the quasi-pulsed voltage source.
LSV Sets the linear search voltage source.
LSSV Sets the linear search synchronous voltage source.
LSI Sets the linear search current source.
LSSI Sets the linear search synchronous current source.
BSV Sets the binary search voltage source.
BSSV Sets the binary search synchronous voltage source.
BSI Sets the binary search current source.
BSSI Sets the binary search synchronous current source.
To Next Page
Loading...
Need help?
General
