Keysight Technologies M9036A User Manual

Keysight M9036A PXIe Embedded Controller User Guide 65
Memory Modules Service
4 Spread the two memory clamps for the module you want to replace.
5 The memory module should pop up. Carefully slide the memory module out of
the edge connector.
To install memory modules, reverse the previous steps. Carefully place the
memory module in the socket. Press the module into the clamps until they lock
the module in place.
Replace the controller module in the PXIe chassis and power it up. The controller
BIOS should automatically detect the new memory.
To verify the amount of memory installed in your controller: from the Start menu,
select Computer. Select System Properties. under System Properties, locate Installed
memory.
Figure 18 M9036A Memory Modules (only the bottom module shown)
Clamp for top module
Clamp for top module
Clamp for bottom module
Clamp for bottom module

Keysight Technologies M9036A Specifications

General

Brand	Keysight Technologies
Model	M9036A
Category	Controller
Language	English