34 Keysight EXG and MXG X-Series Signal Generators User’s Guide
Models, Options, and Front/Rear Panels for All Models
Rear Panel Overview (N5173B & N5183B)
8. 10 MHz OUT
9. GPIB
This connector enables communication with compatible devices such as external controllers, and is
one of three connectors available to remotely control the signal generator.
See also 10. LAN and 11. Device USB.
10. LAN
The signal generator supports local area network (LAN) based communication through this
connector, which enables a LAN–connected computer to remotely program the signal generator.
The LAN interface supports auto–MDIX. The signal generator is limited to 100 meters on a single
cable (100Base–T). For more information on the LAN, refer to the Programming Guide.
11. Device USB
Use this universal serial bus (USB) connector to connect a PC to remotely control the signal
generator.
12. Host USB
Use this universal serial bus (USB) to connect a USB Flash Drive (UFD) for data transfer. You can
connect or disconnect a USB device without shutting down or restarting the signal generator.
13. SD Card
Holds the Secure Digital (SD) non-volatile memory card.
14. ALC INPUT
This input connector is used for negative external detector leveling.
Connector female BNC Impedance nominally 50 Ω
Signal A nominal signal level greater than 4 dBm.
Connector Type B
USB Protocol Version 2.0
Connector Type A
USB Protocol 2.0
Connector female BNC Impedance nominally 100 kΩ
Signal -0.2 mV to -0.5 V
Damage Levels -12 to 1 V
To Next Page
Loading...
Need help?
General
