Keysight E36300 Series - Page 45

DNS Hostname
A hostname is the host portion of the domain name, which is translated into an IP address.
Each power supply is shipped with a default hostname with the format: Keysight-modelnumber-serialnumber,
where modelnumber is the power supply’s 6-character model number (e.g. E36312A), and serialnumber is the last
five characters of the 10-character power supply serial number located on the label on the top of the unit (e.g.
45678 if the serial number is MY12345678).
– The instrument receives a unique hostname at the factory, but you may change it. The hostname must be unique
on the LAN.
– The name must start with letter; other characters can be an upper or lower case letters, numeric digits, or dashes
("-").
– This setting is non-volatile; it will not be changed by power cycling or *RST or SYSTem:PRESet.
1. Press Utilities > I/O Config > LAN Settings.
2.
Select DNS Hostname field using the navigation keys. Press and enter the hostname with the keyboard
provided. Press Back.
3. Press Yes to save the setting.
4. Press No to cancel all the changes and exit without saving.
mDNS Service
The mDNS service name is registered with the selected naming service.
Each power supply is shipped with a default service name with the format: Keysight-modelnumberserialnumber,
where modelnumber is the power supply’s 7-character model number (e.g. E36312A), and serialnumber is the last
five characters of the 10-character power supply serial number located on the label on the top of the unit (e.g.
45678 if the serial number is MY12345678).
– The instrument receives a unique mDNS service name at the factory, but you may change it. The mDNS service
name must be unique on the LAN.
– The name must start with letter; other characters can be an upper or lower case letters, numeric digits, or dashes
("-").
1. Press Utilities > I/O Config > LAN Settings > mDNS Off to configures the service name registered with the
selected naming service automatically.
2. Press Utilities > I/O Config > LAN Settings > mDNS On to configure the service name of the instrument manu-
ally.
3.
Select mDNS Service field using the navigation keys.
4. Press mDNS Srv and enter the service name with the keyboard provided.
5. Press Back to exit.
Keysight E36300 Series User's Guide 45