Keysight E36300 Series - Data Logger View

To Next Page

To Previous Page

To set up the data log for output 1:

SENS:DLOG:FUNC:VOLT 1, (@1)

SENS:DLOG:TIME 30

SENS:DLOG:PER 0.2

To initiate that data logger and specify the filename in which to save the data:

TRIG:DLOG:SOUR BUS

INIT:DLOG “External:\log1.csv”

To turn on Output 1 and run the data logger:

OUTP ON, (@1)

*TRG

Data logger view

Press Data Logger to access the data logger.

Items Description

1 Trace controls Identifies the voltage or current trace that will be displayed. √ indicates the trace is on. Dashes (----) indic-

ate the trace is off. Select the trace and press [Enter] to turn it on or off.

2 Data bar The data bar represents all of the logged data. The yellow part indicates the portion of the data that is vis-

ible on the display. The black part represents the data that is not visible.

3 Time/Div Identifies the horizontal time-base setting. This can be adjusted using the Horizontal Time/Div + and

Time/Div – in Waveform Settings.

Keysight E36300 Series User's Guide

Other manuals for Keysight E36300 Series