6 Keysight E6961A User Guide and Method of Implementation
Figure 1-20 Connection Setup for MDI Return Loss test . . . . . . . . 42
Figure 1-21 Power Spectral Density Test Using N9010A Signal
Analyzer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
Figure 1-22 Typical Spectral Density Loss Test Waveform . . . . . . 46
Figure 1-23 Typical Results Tab . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
Figure 1-24 Top Portion of a Typical HTML Report . . . . . . . . . . . . 48
Figure A-1 Return Loss Impedance Calibration Board . . . . . . . . . 53
Figure A-2 N5395C Ethernet Electrical Transmitter Test Fixture . 53
Figure A-3 Section 11 on the Ethernet Test Fixture. See Table 2 for
Jumper Settings . . . . . . . . . . . . . . . . . . . . . . . . . . . 54
Figure B-1 BroadR-Reach Compliance Test Application Main Menu
58
Figure B-2 BroadR-Reach Compliance Test Application External In-
struments List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
Figure C-1 AWG Calibration Setup for the Disturbing Signal Source
63
Figure C-2 BroadR-Reach Compliance Test Application Main Menu
64
Figure C-3 ENA Calibration Setup . . . . . . . . . . . . . . . . . . . . . . . . . 65
Figure D-1 Keysight’s E6961A-FDB Frequency Divider Board . . . 68
Figure D-2 Check the Use 10MHz Ref Clock on Main Application
Window . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70
Figure D-3 Test Setup for 10 MHz Frequency Reference . . . . . . . 71
To Next Page
Loading...
