96 Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide
3 M8194A Soft Front Panel
BIN5110
Compatibility: Keysight 5110A
Binary int16 I/Q sample pairs (in little endian byte order). May contain full
16 bit DAC values without the marker bits or 14 bit value plus two markers.
When importing 16 bit values without markers the marker flag should be
set to ‘OFF’ so that 8 LSB are ignored.
MAT89600
Compatibility: Keysight 89600 VSA
One file contains waveform samples for one or two or three or four
M8194A channels. It is a 89600 VSA recording file in MATLAB binary
format (.mat) containing floating point values (without markers). Only
MATLAB level 4.0 and 5.0 files are supported.
MATLAB binary files with one, two, three or four columns are supported. If
the MATLAB file consists of one column, the data can be imported to
channel 1 or channel 2 or channel 3 or channel 4. If it consists of multiple
columns, column 1 can be imported to channel 1, column 2 to channel 2,
column 3 to channel 3 and column 4 to channel 4.
If it consists of multiple columns, the handling depends on the number of
available channels.
Four-channel mode: Column 1 can be imported to channel 1, column 2
to channel 2, column 3 to channel 3 and column 4 to channel 4,
Two-channel mode: Column 1 can be imported to channel 1, column 2
to channel 4. If column 2 is not present, column 4 can be imported to
channel 4.
Both real and complex I/Q data formats are supported. For I/Q format the
values are stored as array of complex numbers with the real part
corresponding to I value and the imaginary part corresponding to Q value.
The header variable ‘XDelta’ (1/XDelta) is used to set the currently
selected sample frequency.
To Next Page
Loading...
