Keysight M8194A - Page 97

Keysight M8194A 120 GSa/s Arbitrary Waveform Generator User Guide 97
M8194A Soft Front Panel 3
DSA90000
Compatibility: Keysight DSA90000 Oscilloscope
One file contains waveform samples for one M8194A channel. The
waveform samples can be imported to any of the four M8194A channels.
DSA90000 waveform file in binary format (.bin) containing header and
floating point data (without markers). Only waveform type ‘Normal’ is
supported. If the file contains more than one waveform only the first
waveform will be imported.
CSV
Compatibility: M8190A
One file contains waveform samples for one, two, three, or four M8194A
channels.
Normalized values (-1.0 .. +1.0) and markers in comma delimited format.
Without header information, the columns are pre-defined in the following
way:
• 1 column: waveform data for channel 1
• 2 columns: waveform data for channel 1 & 2
• 3 columns: waveform data for channel 1 & 2 & 3
• 4 columns: waveform data for channel 1 & 2 & 3 & 4
If the file consists of one column, the data can be imported to channel 1 or
channel 2 or channel 3 or channel 4. If it consists of multiple columns, the
handling depends on the number of available channels.
Four-channel mode: Column 1 can be imported to channel 1, column 2 to
channel 2, column 3 to channel 3 and column 4 to channel 4,
Two-channel mode: Column 1 can be imported to channel 1, column 2 to
channel 4. If column 2 is not present (possible when a data header is used,
see below), column 4 can be imported to channel 4.
Examples:
1 channel (without markers):
0.7
0.9
…
2 channel (without markers):
0.7,0.7