Keysight U1732C - Page 14

14 Keysight U1731C/U1732C/U1733C User’s Guide
Figure 3-5 Changing the power-on secondary parameter and measurement
mode for resistance (R) measurements
. . . . . . . . . . . . 75
Figure 3-6 Changing the power-on open/short CAL . . . . . . . . . . 76
Figure 3-7 Changing the Ai function’s phase angle condition . . . 78
Figure 3-8 Changing the power-on limit and category set . . . . . 79
Figure 3-9 Changing the user high/low limit values . . . . . . . . . . . 81
Figure 3-10 Changing the baud rate . . . . . . . . . . . . . . . . . . . . . . . . 82
Figure 3-11 Changing the parity check . . . . . . . . . . . . . . . . . . . . . . 83
Figure 3-12 Changing the data bits . . . . . . . . . . . . . . . . . . . . . . . . 84
Figure 3-13 Changing the beep frequency . . . . . . . . . . . . . . . . . . . 85
Figure 3-14 Locking the push buttons . . . . . . . . . . . . . . . . . . . . . . 86
Figure 3-15 Changing the auto power-off and backlight
time-outs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87
Figure 3-16 Resetting the Setup items . . . . . . . . . . . . . . . . . . . . . . 88