Keysight U1732C - Power-On Options; Table 1-2 Power-On Options

1Introduction
26 Keysight U1731C/U1732C/U1733C User’s Guide
Power-on options
Some options can be selected only while you turn the LCR meter on. These
power-on options are listed in the table below.
To select a power-on option, press and hold the specified key in Table 1-2 while
turning the LCR meter ON ( ).
Table 1-2 Power-on options
Key Description
Tests the LCD.
All annunciators are displayed in the LCD. Press any key to exit this mode.
Simulates the Auto Power-Off (APO) mode. Press any key to turn the LCR meter back on and resume
normal operation.
Checks the firmware version.
The LCR meter’s firmware version will be shown on the primary display. Press any key to exit this mode.
Performs the Open/Short CAL on all frequencies and all ranges for the User mode ( ).
[1]
Enters the Setup menu.
See Chapter 3, “Setup Options,” starting on page 65 for more information. Press and hold for more
than 1 second to exit this mode.
[1] The Open/Short CAL requires approximately 1.5 minutes to complete.
Rec
Hold
Auto
Range
Cal
Null
PS
ZLCR
PS
ZLCR