Keysight U1732C - Figure 3-3 Changing the Power-On Secondary Parameter and Measurement Mode for Inductance (L) Measurements

Setup Options 3
Keysight U1731C/U1732C/U1733C User’s Guide 73
Changing the power-on secondary parameter and measurement mode
for inductance (L) measurements
Use this Setup item to change the inductance (L) measurement’s initial secondary
parameter — dissipation factor (D), quality factor (Q), or phase angle (θ) — and
measurement mode — parallel or series.
The inductance (L) measurement will start up using the selected secondary
parameter and measurement mode for subsequent power cycles.
Figure 3-3 Changing the power-on secondary parameter and measurement
mode for inductance (L) measurements
Press
Press
Press
Press
Press
Press
Press
Press