Keysight U1732C - Setup Menu Items; Changing the Initial Power-On Behavior

3Setup Options
70 Keysight U1731C/U1732C/U1733C User’s Guide
Setup Menu Items
Changing the initial power-on behavior
You can change the power-on behavior of your LCR meter for subsequent power
cycles.
Changing the power-on measurement type
Use this Setup item to change the LCR meter’s initial measurement type. You can
set the LCR meter to start up in the
– auto identification mode (Ai),
– impedance measurement (Z),
– inductance measurement (L),
– capacitance measurement (C),
– resistance measurement (R),
– equivalent series resistance mode (ESR), or
– direct current resistance mode (DCR) for U1733C only
Parameter Range Default setting
Pon-tYPE Ai, Z, L, C, R, ESR, or DCR Ai
Pon-FrEq 100 Hz, 120 Hz, 1 kHz, 10 kHz, or 100 kHz 1 kHz
Pon-AUto (L)
–D, Q, or °θ
– Parallel or Series
–Q
–Series
Pon-AUto (C)
–D, Q, or °θ
– Parallel or Series
–D
–Series
Pon-AUto (R)
–D, Q, or °θ
– Parallel or Series
–°θ
–Series
Pon-oSC FACt or USEr FACt