Keysight U1732C - Figure 3-5 Changing the Power-On Secondary Parameter and Measurement Mode for Resistance (R) Measurements

Setup Options 3
Keysight U1731C/U1732C/U1733C User’s Guide 75
Changing the power-on secondary parameter and measurement mode
for resistance (R) measurements
Use this Setup item to change the resistance (R) measurement’s initial secondary
parameter — dissipation factor (D), quality factor (Q), or phase angle (θ) — and
measurement mode — parallel or series.
The resistance (R) measurement will start up using the selected secondary
parameter and measurement mode for subsequent power cycles.
Figure 3-5 Changing the power-on secondary parameter and measurement
mode for resistance (R) measurements
Press
Press
Press
Press
Press
Press
Press
Press