1Introduction
34 Keysight U1731C/U1732C/U1733C User’s Guide
Display screen
The function that each display annunciator of your LCR meter is associated to is
described in this section. See also “Measurement units” on page 37 for a list of
available measurement signs and notations.
General display annunciators
The general display annunciators of your LCR meter are described in the table
below.
Each display annunciator of the U1731C/U1732C/U1733C display screen (shown
in Figure 1-7) is described in Table 1-6. Click the respective “Learn more” pages in
Table 1-6 for more information on each annunciator.
Table 1-6 General annunciators
Legend Description Learn more on:
Remote control via PC indicator page 25
Equivalent series resistance indicator
Resistance measurement by direct current indicator
LCR meter using open/short CAL settings by factory
page 62
LCR meter using open/short CAL setting by user
Measuring frequency of test signal is 100 Hz
page 53
Measuring frequency of test signal is 120 Hz
Measuring frequency of test signal is 1 kHz
Measuring frequency of test signal is 10 kHz
Measuring frequency of test signal is 100 kHz
To Next Page
Loading...
