Keysight U1732C - Figure 2-16 High and Low Limit Values; Figure 2-17 Ngo and Go Indications

2 Features and Functions
60 Keysight U1731C/U1732C/U1733C User’s Guide
You may press or again to toggle between the high (H) or low (L) values
shown on the primary display.
Figure 2-16 High and low limit values
Press while the annunciator is flashing to start the comparison. (If no
activity is detected after 3 seconds, the comparison will also begin.)
The LCR meter beeps three times and displays in the secondary display if the
reading is greater ( ) than the high limit or lesser ( ) than the low limit.
If the reading is within the high and low limits, the meter beeps once and displays
in the secondary display.
Figure 2-17 nGo and Go indications
The limit set used in the comparison is displayed after the / indication.
Press and hold for more than 1 second to exit this mode.
Limit
DQO
Auto
Range
Rec
Hold
Limit
DQO