KLS Martin marLED E9 - Page 21



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E15E9 / E9i / E15
V V 1.0 1.0 2121
1 1 Power Power modulemodule
SMPS 36/9 S3 U L (-N)SMPS 36/9 S3 U L (-N)
100–240 VAC 50–60 Hz100–240 VAC 50–60 Hz
Input current 3.5–1 AInput current 3.5–1 A
Output Power Max. 290 VA (28–36 VDC)Output Power Max. 290 VA (28–36 VDC)
2 2 Rotary Rotary potentiometer potentiometer (adjustment)(adjustment)
to set the output voltage 28–36 VDCto set the output voltage 28–36 VDC
F11 only for IT grids (ungrounded powerF11 only for IT grids (ungrounded power
supply)supply)

Plug:
Plug: Plug Plug type: type: Fuse Fuse rating:rating:
X1 X1 Input Input 100–240 100–240 VAC, VAC, 50–60 50–60 Hz Hz F1 F1 / / F11F11
X3 X3 Output Output 28 28 - - 36 36 VDC VDC T5 T5 AH250VAH250V
Connection
Connection data data for for clamps clamps X1 X1 X3X3
Conductor Conductor cross-section cross-section flexible flexible max. max. 2,5 2,5 mm mm 16 16 mmmm
Conductor Conductor cross-section cross-section with with conducter conducter sleeve sleeve max. max. 2,5 2,5 mm mm 16 16 mmmm
For IT grids (Power supply:For IT grids (Power supply:
II
nsulated, health protection: KLS Martin power module providesnsulated, health protection: KLS Martin power module provides
grounding (Frenchgrounding (French TTerre) with fuses (F1 and F11) for both cable cores (L1, L2). In case oferre) with fuses (F1 and F11) for both cable cores (L1, L2). In case of
standard grids with grounded zero conductor, the power modules (A1.1) must be used withstandard grids with grounded zero conductor, the power modules (A1.1) must be used with
secured phase (only F1 for L).secured phase (only F1 for L).