KLS Martin marLED E9 - Programm Programming Ing



Service ManualService Manual
Operating Lights marLEDOperating Lights marLED
®®
E9 / E9i / E9 / E9i / E15E15
56 56 V V 1.01.0
Without an interface adapter connected, malfunction may Without an interface adapter connected, malfunction may result!result!
Always link the connecting cable (5) with the interface adapter attached (6) to the lamp.Always link the connecting cable (5) with the interface adapter attached (6) to the lamp.
Risk of damage to propertyRisk of damage to property
Non-compliance may lead to property damage (loss of time, loss of data, machinery defects,Non-compliance may lead to property damage (loss of time, loss of data, machinery defects,
etc.)!etc.)!
6.19.36.19.3

ProgrammingProgramming
Two different DSPs (Digital Signal Processors) are installed on the circuit board of the marLEDTwo different DSPs (Digital Signal Processors) are installed on the circuit board of the marLED
®®

E9 / E9i / E15 which must be programmed with different programs. The DSPs areE9 / E9i / E15 which must be programmed with different programs. The DSPs are
discriminated as Master and Slave.discriminated as Master and Slave.
The programming is done via the same connection and the programming software C2Prog.The programming is done via the same connection and the programming software C2Prog.
Setup and connectionSetup and connection
•• Turn off supply voltage of the marLEDTurn off supply voltage of the marLED
®®
E9 / E9i / E15.E9 / E9i / E15.
••
 Connect RS232 interface (3) of the computer via interface adapter to the marLEDConnect RS232 interface (3) of the computer via interface adapter to the marLED
®®
E9 / E9i / E15 at connection X7 (1, 2).E9 / E9i / E15 at connection X7 (1, 2).
NOTICENOTICE
NOTICENOTICE